The laying of tiles shall retain a slope of 1% of the discharge, and the slope shall face the falling water. The waterproof, construction process and material selection of the bathroom space are equally important. Tile seams should be the same thickness, aligned with the wall tile seams, and should be leveled when the tiles are attached. The water in the bathroom space can be discharged as soon as possible. Before the construction of the brick wall, the waterproofing of the wall is first performed to ensure that the wall is completely waterproof.
Bathroom equipment installation should be humane
As far as possible, the necessary items for different bathing stages should be stored separately in the order of dry and wet separation, and they should be easily accessible during bathing. When choosing and installing sanitary ware, consider the humanization of its design. The sleek curve can reduce the damage caused by the bump. If the space is relatively large, you can also consider separating the shower space from the makeup and toilet space to effectively prevent splashes from splashing and keep the floor dry. These can be fitted with fixed, fully enclosed partition doors and partial shelters.
Safe little details are most easily overlooked
Electrical switch should be as far as possible outside the bathroom, bathroom space lines must be sealed waterproof and insulation treatment. If there is a socket in the bathroom, it should be kept away from water. It is best to cap it, and keep in mind that wet hands do not pull out the socket.
Water heater installation and use should pay special attention to safety, not only the safety performance of the water heater itself will affect the bathroom safety, ventilation and ventilation capacity of the bathroom space is also very important. If the ventilation capacity of the window is limited, the exhaust fan of the retrograde gate may be installed, and the gap between the bathroom door and the ground may also be left larger.
Bathroom renovation construction knowledge space socket switch electrical window partition door
Smco1:5 magnet is also named Smco5. Prorated with metallic samarium, cobalt and metallic praseodymium, are firstly those roughcasts with different properties and grades after series technology processing from melting, milling, and pressing to sintering in order. The (BH)max range is from 16 to 25, maximum working temperature 250 ℃. The physical character and ductibility of Smco5 is better than Sm2Co17, so Smco5 is slightly easier to be machined thin thickness disc or ring wall and complex shapes while Sm2Co17 is more brittle. Magnetization magnetic field of Smco5 is lower than Sm2Co17's. In general, Smco5 can be magnetized saturated by 4000Guass magnetic field. However, magnetizing Sm2Co17 with high Hcj value need more than 6000guass magnetic field. These days, prices of rare earth material improved significantly, and the level of rare earth material around the magnet is up to 40%. For these reasons, the price of Smco5 is more expensive than Sm2Co17. According to different using circumstance, customers can choose SmCo5 or Sm2Co17 reasonably.
Smco5 Magnet,Sintered Smco Magnet,Permanent Smco Disc Magnet,Watch Smco Magnets
Jinyu Magnet (Ningbo) Co., Ltd. , http://www.magnetbonwin.com