The pump is a cantilever single-stage single-suction centrifugal pump, can adapt to different working conditions, the pump is resistant to corrosion and wear, has been widely used in smelting, sulfuric acid, environmental protection and other industries. What should we pay attention to when installing the sand pump? Xiao Bian below for you to answer the installation of four major considerations mud pump. Mortar pump installation Four Notes 1, the impeller cap and retaining ring after the relative nut Tight, check the gap between the impeller and the pump body, the gap requirements of about 2.5mm; 2, the pump cover is installed After checking the gap between the pump cover and the impeller (from the exit at the inside look), this gap should be guaranteed at about 2mm, high temperature medium pump, the gap required at 2.5mm; 3, between the impeller and the pump Gap does not meet the requirements, by increasing or decreasing the pad between the impeller and sleeve to be adjusted; 4, the gap between the pump cover and the impeller does not meet the requirements, by increasing or decreasing the pump body and the pump cover Spacer to adjust. Above is some attention to the installation of sand pump, I hope it helps. Industry Internet (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: Zeng Fenfen (QQ / WeChat: 235592927) http://beng.liuti.cn/ (Service Hotline: 400-6030-811)