For home decoration, people usually hold the traditional concept of “not to be allowed to move†in winter and wait until spring to start the decoration. In fact, as long as you pay attention, you can also decorate in the winter. When spring comes, you can sit in your new home and enjoy the spring festival.
Design is not greedy "warm" far-reaching decoration
Caution 1 Do not overuse warm colors
It must be reminded that winter home-use design tends to use warm colors to increase the warmth of the interior, but if you use warm colors excessively, you will feel hot inside the house during the summer. Therefore, it is best to use the intermediate color to adjust it properly.
Note 2 Temperature difference during construction
The sudden drop in winter temperatures and rapid weather changes can shrink building materials and cause water to evaporate. Therefore, during winter decoration, the main materials (especially wood) used should be prepared in advance, preferably in a heated room for 3 to 5 days. This will allow the moisture content of the wood to be close to that of the house so as to avoid deformation; Sand should be carefully sifted, there can be no ice, according to the actual construction needs to add some antifreeze properly, the temperature of the water mixing mortar can not exceed 80 °C, the cement to do a good antifreeze; paint application must be strictly in accordance with the instructions, painting After the room has to wait until it is fully dry before opening the doors and windows for ventilation, if the temperature is too low, the paint will deteriorate or even become powdery.
Note 3 Precautions against breakage and cracking of wall tiles and floor tiles
In winter construction, no matter whether it is a wall brick or a floor tile, it needs to transition for 24 hours after being transferred from the outside to the room to avoid the phenomenon of hollowing or falling off after construction. In winter, the indoor air is dry and the water loss is fast. Therefore, the putty cannot be scraped too thick, otherwise it is easy to cause emptying, cracking, and wall inequality. In case of strong winds and cool weather, it is best not to carry out oil work because paint and paint are prone to dust when they are dry. Putty does not dry on the paint, the wall will appear "sweat" phenomenon and even a large area of ​​cracking phenomenon, often window ventilation, the best time in the relatively high temperature between 10 am to 4 pm.
Note 4 wood products reserved gap
Due to the principle of thermal expansion and contraction, in the construction of wood products in winter, we must pay attention to keep a certain gap: the door seam should not be too small, so as to avoid the summer door tight, can not switch freely; when laying solid wood flooring, set aside 2 mm Left and right expansion joints, otherwise it will cause a drum, dangling phenomenon; furniture, the need to leave about 0.1 mm seam interface to avoid deformation; when the gypsum board ceiling operation, the moisture content of wood keel must be controlled below 12% And the keel must be firm and can not be loosened, so that cracks in the gypsum board ceiling can be prevented. Between the gypsum board, between the gypsum board and the wall, a gap of about 0.5 cm is left. Gypsum powder and latex are used to reconcile the gaps. Then the double kraft paper is scraped and the plaster is no longer cracked. .
Note 5 Acceptance is focused
After the winter decoration, the focus of acceptance should be on the left seams, stickers, and patches, and carefully check for cracking. Also look carefully at the floor for obvious gaps and irregularities, and whether the floor and skirting board joints are in close contact. However, some gaps are allowed due to the fact that the wood floors are laid in the winter.
Note 6 inspection decoration green
After finishing the decoration, arrange the furniture, immediately open the window and ventilate, and then stay for a few days to stay again to avoid concentration of a large amount of harmful substances. All the furniture should be open and the door should be left open for a few days before hanging clothes. It is best to have a qualified indoor air testing department do an air test. If it is not qualified, immediately ask the experts to find out the source of harmful substances, and ask the workers to rework to eliminate potential poisoning hazards.
Experience on the entrance decoration children's room decoration interior decoration window furniture paint paint floor tiles home decoration home improvement home decoration home
Glass Straight Line Beveling Machine
SHENZHEN HUACAI GLASS MACHINERY CO.,LTD , http://www.hcglassmachinery.com