Wall treatment: remove the surface impurities and floating soil with scraper and sandpaper, and grind the cracks with gypsum powder. If the wall texture is soft or has a powder layer, you should first apply the wallpaper glue to make the wall firm, and the wallpaper will not fall off.
Cut the wallpaper: first measure the height of the wall, then cut the length of the wallpaper. There are two cases: the length of the wall is not limited to 10 cm, and the length is about 10 cm, which is used for upper and lower trimming. For the wallpaper, the symmetry of the pattern needs to be considered. Therefore, the cutting length should be increased according to the actual situation, usually 10 cm longer. the above.
Applying glue: Apply the wallpaper glue to the back of the cut wallpaper with a brush. Pay special attention to the surrounding edges to be glued to ensure the construction quality. The painted wallpaper is applied to the surface for 5 minutes, so that the glue can be completely penetrated into the bottom of the paper and then posted. Number of brushes per shot
Wallpaper construction: Use a quasi-heart hammer to measure the vertical reference line, and post the first wallpaper from top to bottom according to the baseline, and squeeze out the bubbles and excess glue to make the wallpaper flat against the wall.
Trimming cleaning: Cut off the excess wallpaper at the upper and lower ends. The knife should be sharp to avoid burrs. Then use a clean wet towel or sponge to wipe off the glue remaining on the surface of the wallpaper to avoid yellowing the wallpaper. If the surface of the wallpaper is found to have air bubbles after drying, use a knife to cut the injection glue and then flatten it to eliminate it.
Power switch and socket sticker method: first turn off the main power supply, then cover the entire power switch or socket, cut two diagonal lines from the center point, there will be 4 small triangles, then use the utility knife along the power switch Or remove the excess wallpaper around the socket. Finally wipe off the excess adhesive with a rag.
4 Axis Square Pipe&Sheet Plasma Cutting Machine mainly for 4 axis 3D square pipe cutting.
1. This design fit for multifunction cutting requirements: both metal sheet and square pipe continuous cutting
2. Accept OEM for any pipe cutting diameter and working length. ( Normally from 100x100mm up to 600x600mm dia. )
3. Accept OEM for any table size: likes 4x4, 4x8 Plasma Cutting Table
4. Accept any materials cutting: Iron plate, Stainless steel plate, Titanium plate, Galvanized sheet, Aluminum plate, High speed steel, etc
4 Axis Square Pipe & Sheet Cutting Machine
Tube Cutting Machine,4 Axis Square Pipe Cutting Machine,4 Axis Square Pipe,Cnc Tube Cutter
Jinan Huaxia Machinery Equipment CO.,Ltd , http://www.cnformingmachine.com