How to use variable speed bearings?

Source: Bearing network time: 2018-07-17

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

The use of variable speed bearings:
1. Consider the shape and connection scale of the variable speed drive bearing.
2, variable speed drive bearings can be horizontally settled; can also be vertical or skewed to settle. Can be forward and reverse rotation. Positive and negative input and output power (ie deceleration or speed increase).
3. No matter what kind of device method is used for variable speed transmission bearing; there is a need for scale cooperation with its coupling parts.
Recommended selection: cooperation between the inner ring hole d and the shaft according to H7/h6, cooperation between the pin hole and the transmission of the middle ring according to H7/r6, cooperation of the outer ring D and the housing according to H8/h7, transmission and output shaft hole The cooperation uses gap cooperation; the gap volume is 0. 2~0. 5mm. Valve imported pump industrial washing machine 4, axial positioning of variable speed transmission bearing: one of the three turns of the axial position is positioned; the other two axes are not Need to be positioned again.
5, the direction of the transformation, the outer ring and the inner ring are flat key positioning. The middle circle is using the drive positioning.
6. The variable speed transmission bearing can accept a small external force in the radial direction; however, it is not suitable to accept a large working load.
7. Transmission ratio; both are transmission ratios according to the first device method. If other device methods are used; the transmission ratio should be calculated.
8. At the extra speed (1500 rpm); select the variable speed drive bearing type according to the required power (Kw).
9. When based on the working torque; the type should be selected accordingly.
10. The choice of the type of reducer is the same as the type of variable speed drive bearing.

Recommend to friends comments close window

Bearing related knowledge

How to protect the classification of the front and rear wheel bearing rolling bearing fault diagnosis skills (2)
General information and requirements for bearing outer packaging. The development of steel for Japanese ball bearings is not the same as the advantages of self-smooth bearings.

This article links to http://
Please indicate China Bearing Network http://

Previous:The torque, load and life of the bearing (2)
Next: Talking about the working principle of hydrostatic bearings

Window Screen is usually made of Galvanized Iron Wire, stainless steel wire and aluminum wire. It is widely used as mosquito screen, window screen, door screen and filter screen. The plain wave one is very common. The plain wire cloth is not crimped before weaving, with the same diameter warp and shute Wires woven in a simple over and under pattern.

Features

ÂŸ Mesh: Number of openings per inch in horizontal and vertical directions.

ÂŸ Woven type: Plain weave.

ÂŸ Type of edge: Rough selvedge, wrapped selvedge.

Window Screen

Galvanized Wire Mesh Screen,Aluminum Wire Screen,Stainless Steel Wire Mesh

DINGZHOU TIAN YILONG METAL PRODUCTS CO., LTD. , http://www.wiremeshsolution.com